News and Events

Are there preferred analysis tools for CAN Bus testing?

19/09/2019

Error-frames are very rare and in a good system there should be no Error-frames. Even if you have Error-frames there… Read More

Read More

Best practices of handling CAN Bus errors?

19/09/2019

With good cabling there will be no Error-frames to handle. If you get Error frames it should be registered by… Read More

Read More

LIN with Python

18/09/2019

“Using the Kvaser 2x CAN/LIN device, find and example program to send LIN commands through python so i can test… Read More

Read More

LIN Interfaces – Do I need to apply a V+ for the Reference Voltage pin (pin 9).

18/09/2019

Yes! The V+ must always be connected. Check the user’s guide. (The reference voltage range is 6 to 27 volts… Read More

Read More

We logged data with our Memorator. Do Kvaser have a tool for to view logged data?

18/09/2019

Kvaser do not develop any data visualizing software. However, you may use Kvaser CANlib SDK to develop your own program.… Read More

Read More

Memorators sold with “non valid disk”

18/09/2019

Recommendation: (When taking a new Memorator out of the box) Upgrade the firmware Initialize the disk Set the clock Update… Read More

Read More

Do I need a splitter cable for Kvaser USBcan Pro 5xHS?

18/09/2019

The Kvaser USBcan Pro 5xHS has five CAN channels integrated in a single 26-pin HD D-SUB connector. A five channel… Read More

Read More

Is my interface galvanic isolated?

18/09/2019

All Kvaser interfaces (2019-02-08) is now galvanic isolated. All our Memorators are also galvanic isolated when used as interfaces. If… Read More

Read More

My Leaf Light HS V1 creates noise on CAN bus

18/09/2019

Because the Leaf Light HS (00241-8) or the Leaf Light J1939-13 (00642-3) are not galvanic isolated it is most important… Read More

Read More

Do you recommend adding an external terminator to the device?

18/09/2019

Yes and no! Every CAN bus must be terminated with a 120 Ohm resistor at each end of the bus.… Read More

Read More